マシンを動かしましょう

マシンを動かしましょう
よくある問題
Reference code:
あてはまる項目を選択してください
あてはまる項目を選択してください
Reference code:
あてはまる症状を選択してください。
Reference code:
Only check the light if it is safe to do so.
If there is any doubt please contact an electrician or maintenance personnel.
照明は安全な場所に設置されていますか?
Reference code:
明るさ調節スライダーのタイプ
Analogue dimming, this is usually referred to as 1-10v dimming.
DALI - A lighting management control system.
AC mains/TRIAC
AC/TRIAC dimmers are designed for resistive loads such as incadescent or halogen lights. These phase controlled dimmers are not compatible with LEDs since LEDs do not appear as a resistive load.
Reference code:
Please consult an electrician as to whether the light has been installed with a compatible dimmer.
Reference code:
The product needs to be installed with a compatible dimmer in order to adjust the brightness.
Compatible dimmer - OSram DALI MCU
Reference code:
明るさ調節スライダーのタイプ
Analogue dimming, this is usually referred to as 1-10v dimming.
DALI - A lighting management control system.
AC mains/TRIAC
AC/TRIAC dimmers are designed for resistive loads such as incadescent or halogen lights. These phase controlled dimmers are not compatible with LEDs since LEDs do not appear as a resistive load.
どのようなスライダーがインストールされていますか?
Reference code:
Please disconnect the DALI system. If the light is operational it should power on.
You may need to speak to your DALI engineer to resolve this issue.

Reference code:
As the light is working when the DALI is not connected, it is likely to be an issue with the DALI system.
Please contact your DALI engineer to resolve this issue.
Reference code:
The light is not compatible with AC/Mains Triac, it will need to be installed with a compatible dimmer in order to dim.
Compatible dimmer - OSram DALI MCU
Reference code:
Please disconnect the DALI system. If the light is operational it should power on.
You may need to speak to your DALI engineer to resolve this issue.

Reference code:
As the light is working when the DALI is not connected, it is likely to be an issue with the DALI system.
Please contact your DALI engineer to resolve this issue.
Reference code:
The product is not compatible with analogue controls, it will need to be installed with a compatible dimmer, or an analogue to DALI converter, in order to properly function.
Compatible dimmer - OSram DALI MCU
Reference code:
This issue can be resolved by reinstalling the light. Cu-Beam Down light is designed to be hung over a table and not used as general lighting for a room.
Please refer to the installation guide.
Reference code:
テーブルの天板から1~15mの位置に製品を取り付けてください。

テーブルからどのくらいの高さに照明は取り付けられていますか?
お客様ご自身で配線を交換された場合、保証は無効となります。製品には、ダイソンの仕様に合わせた配線が使用されています。
Reference code:
The trim blades are the four plastic blades that connect to the rectangular baffle of the downlight.

ブレードが正しく設定されているか、設置ガイドで確認してください。
Reference code:
This issue could be caused by the table surface.
Please note, the Cu-Beam downlight is not suitable for use over glass or reflective surfaces.
Reference code:
明るさ調節スライダーのタイプ
Analogue dimming, this is usually referred to as 1-10v dimming.
DALI - A lighting management control system.
AC mains/TRIAC
AC/TRIAC dimmers are designed for resistive loads such as incadescent or halogen lights. These phase controlled dimmers are not compatible with LEDs since LEDs do not appear as a resistive load.
Reference code:
The product needs to be installed with a compatible dimmer in order to adjust the brightness.
Compatible dimmer - OSram DALI MCU
Reference code:
Please consult an electrician as to whether the light has been installed with a compatible dimmer.
Reference code:
あてはまる症状を選択してください。
Reference code:
お客様ご自身で配線を交換された場合、保証は無効となります。製品には、ダイソンの仕様に合わせた配線が使用されています。
付属の電源コードは、本製品専用に設計されています。付属の電源コード以外のコードは使用しないでください。付属の電源コード以外を使用した場合、メーカー保証は無効となります。
Reference code:
ヒューズを確認する
How to test a fuse:
Turn off the light and remove power supply. Ensure that there is no power to the light before removing the fuse.
Turn the meter on and set it to OHMS.
Put one lead on each end of the fuse and check the display on the meter.
Please note; All electrical installation and repair work should be carried out by a qualified electrician in accordance with current local codes or regulations.
Fuse type - 4 AMP 250v Fuse.
ヒューズが飛びましたか?
Reference code:
The DALI (Digital Addressable Lighting Interface) is a data protocol and transport mechanism. The common platform of DALI enables equipment from different manufacturers to be connected.
In this instance, we use this as a lighting management control system.
Reference code:
Please disconnect the DALI system. If the light is operational it should power on.
You may need to speak to your DALI engineer to resolve this issue.

Reference code:
As the light is working when the DALI is not connected, it is likely to be an issue with the DALI system.
Please contact your DALI engineer to resolve this issue.
Reference code:
あてはまる項目を選択してください
Reference code:
あてはまる項目を選択してください
申し訳ございません。オンラインサポートで対応できません。
ダイソンお客様相談室のアドバイザーが対応いたします。
問題は解決しました。
オンラインサポートをご利用いただきありがとうございました。
ダイソンの保証

ハウツービデオとヒント
マシンを最大限に活用できるようにするため。早くて簡単。

オーナー限定の特典
新しいダイソンテクノロジー、イベント、特典のプレビューへの優先アクセス。

専門家の助言。
本物のダイソン担当者から、あなたのマシンにぴったりのアドバイスが届きます。

手間のかからない修理と交換
保証期間中は無料で部品交換または修理が可能です。また、修理できない場合は交換させていただきます。